Hold the 'Set' button for 2 seconds and release when you notice the hour digit is flashing. Press the 'Adjust' button to increase the digits to the correct hour. Continue scrolling through the numbers until the 'AM' or 'PM' label on the screen is correct for the hour you are setting. Press the 'Set' button to cause the minutes digits to begin flashing. Push the 'Adjust' button to increase the digits to the correct number of minutes past the hour. Hitting the 'Set' button again gives you the ability to use the 'Adjust' control to change the seconds, date, month and year.
Office Manuals and free pdf instructions. Find the office and computer equipment manual you need at ManualsOnline.
![Sharp 14 Clock Manual Spc364 Sharp 14 Clock Manual Spc364](http://przystan.info/wp-content/uploads/2018/08/atomic-bedside-alarm-clock-digital-atomic-alarm-clock-with-blue-back-light-r-wave-atomic-bedside-alarm-clock-hito-atomic-bedside-desk-travel-alarm-clock-manual.jpg)
Push the 'Mode' button again to return to the main time screen. Radio Set Stand at least 8 feet from televisions, computers and other electronics to activate the radio control setting function on the Sharp atomic clock. Standing near a window and waiting until the sun has set makes it easier for the unit to receive the signal.
Press the 'Receive' button to begin the search for the radio signal. The clock searches automatically for 8 minutes. Wait for the satellite logo to start flashing and the time to change. Slide the tip of a paper clip into the 'Reset' hole and push the internal button if the time fails to automatically set after the first attempt. Push the 'Receive' button again to begin the search for the radio signal. Move to a different location or leave the Sharp atomic clock manually set if you are unable to receive a signal after multiple attempts.